Posted on

Replacing Harris Bipod Mount with LaRue Tactical LT706

LaRue Tactical LT706 Low Profile Quick Release Disconnect Mount for Harris Engineering S-Series Bipod
LaRue Tactical LT706 - Harris Bipod Mount Replacement

Remove the hex screw from the tension knob and set aside for later use.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Discard the factory chassis as it will not be used with the replacement mount.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Keep the washers, the rod, the knob screw and the rod pin for later use.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Grease both sides of the round washer and the post then replace washer as shown here.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Insert the new mount. Pay attention to the left/right orientation of the speed lever.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Grease the front/bottom portion of the mount and then replace the slotted washer as shown here.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Take the rod pin and insert it into the rod as shown here.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Replace and seat the rod & pin through the post and atop the slotted washer as shown here.

LaRue Tactical LT706 - Harris Bipod Mount Replacement

Place your thumb over the rod & pin to hold it into place while flipping the bipod over. Now install the new LaRue knob and tighten in place with the factory hex screw to the point that the knob can only be turned 1 full rotation from the tightened position.

Download “Replacing Harris Bipod Mount with LaRue Tactical LT706″PDF

Buy on Amazon